Greyline Instruments Inc. - Non-Contacting Flow Solution for Heap Leach Mining

Greyline Instruments

GREYLINE PRODUCTS

Download Product Brochure

Download Product Catalogue

APPLICATION NOTES & CASE STUDIES

Non-Contacting Flow Solution for Heap Leach Mining

Minera Escondida Copper MineThe Atacam Desert, Chile
Minera Escondida Copper Mine The Atacam Desert, Chile

How do you measure the flow rate of a highly corrosive solution in a partially full pipe?

Minera Escondida, the world's largest single producer of copper, was faced with a challenge in their heap leaching process in the Atacama Desert of northern Chile. Finding an accurate, reliable non-contacting flow meter was a difficult task. But Greyline Instruments developed a unique area-velocity flow meter to fully meet the mine's needs.

The Process

In the heap leaching process, crushed sulfide ore is heaped onto lined leach pads where an acidic solution is sprinkled onto the ore. It percolates down through the heap until it reaches the liner at the bottom. The leach solution containing the dissolved metal flows out of the heap through partially full pipes (16” to 42” HDPE pipes) at velocity rates between 1-3 m/sec. Monitoring flow in the collection pipes contributes to better control of the process, increased mineral recovery and reduced leach cycles.

The Problem

Shut down of the leaching process was not an option for Minera Escondida. So the flow meter had to be designed so that it could be installed with continuous flow in the partially filled pipes. It also had to be noncontacting so that it would not be affected by the highly corrosive acidic solution. Francisco Southernland, Senior Engineer at Minera Escondida, turned to VSI Ltda of Chile, the representative for Greyline Instruments, for a solution to monitor flow in this difficult application.

Greyline AVFM 5.0 Area-Velocity Flow Meter
Greyline AVFM 5.0 Area-Velocity Flow Meter with Non-contacting Ultrasonic Level and Clamp-on Velocity Sensors

The Solution

VSI and Greyline Engineer Jose Castro configured Greyline's AVFM 5.0 Area-Velocity Flow Meter with a combination of two nonintrusive sensors: a clamp-on Doppler velocity sensor to monitor the flow velocity, plus a down-looking ultrasonic level sensor to measure level. Both sensors work from the outside of the pipe so there is no obstruction to flow and no contact with the fluid. Stand pipes were added to the pipes so that the non-contacting ultrasonic level sensors were elevated above the flowing solution. By measuring velocity and level of the flowing solution, and knowing the pipe diameter, the Greyline AVFM 5.0 Area-Velocity Flow Meter is able to accurately monitor the flow rate. The flow meter displays, totalizes and transmits the flow rate in real time to the mine's control system.

The first Greyline meters were installed in January 2013 and since then 44 AVFM 5.0 Area-Velocity Flow Meters have been deployed in the project. Engineers at Minera Escondida now have a better understanding and greater control of mass balance, evaporation and other physical mechanisms controlling this complex process which will increase the amount of copper recovered and reduce the time of leach cycles. Greyline's AVFM 5.0 with a combination of two nonintrusive sensors: a clamp-on Doppler velocity sensor plus a down-looking ultrasonic level sensor has proved to be a unique, safe and effective solution.

Resources

AVFM 5.0 Area-Velocity Flow Monitor

www.bhpbilliton.com/home/businesses/copper/Pages/default.aspx

Canada

Greyline Instruments Inc. Canada
16456 Sixsmith Drive, Long Sault, Ont. K0C 1P0
Tel: 613-938-8956 • Toll Free: 855-300-9151
Fax: 613-938-4857 • E-mail: info@greyline.com

United States

Greyline Instruments Inc. United States
11451 Belcher Road South, Largo, FL 33773
Tel: 315-788-9500 • Toll Free: 888-473-9546
Fax: 315-764-0419 • E-mail:  info@greyline.com

We Accept

Follow Us